Can Trailer Running Lights be Activated At Night When Wanted
Updated 10/27/2020 | Published 10/24/2020
Products Featured in This Question
Question:
I would like my running lights on my 5th wheel to be on at night, not hooked up to my truck. Less obtrusive than the outdoor patio lights. My thought to make this work would be to buy “Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket” and run two wires to 12volt. See picture. Would this work?
asked by: Lee
Expert Reply:
You could run a wire from your trailer's battery to the running light circuit and then use a switch like part # D16740 to activate them when needed. This would also allow the lights to function when not connected to the tow vehicle as well.
Product Page this Question was Asked From
Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole - Ford, GM, Dodge, Nissan w/ Factory Plug
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- No Tow Package
- 7 Blade
- Plug and Lead
- Plug-In
- Pollak
more information >
Continue Researching
- Q&A: Does Landing Gear Leg LC179013 Attach Directly to Motor
- Q&A: Recommended 5th Wheel Wiring Harness for a 2024 Ram 2500
- Q&A: Is There an Aftermarket 5th Wheel Prep Package for a 2026 Ram 2500?
- Article: Trailer Wiring Diagrams
- Article: Ram Trailer Tow Prep Package
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Recommended Black Armour Heavy-Duty Trailer Mat
- Q&A: Recommended Air Bags for a 2026 Ram 3500 w/ the Factory Puck System
- Q&A: Can Firestone Air Bags Be Installed In A 1999 Ford F-350 With A B&W Turnoverball Already Installed
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Fifth Wheel Hitch Combinations for Ram Trucks with RamBox (2009-Current)
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing