Replacement Head Pin for Solera Awning

Question

Question:

I need a head pin that is believed on both end witch one do I need the pictures do not match what the reviews say

asked by: Thomas E

0

Expert Reply:

It looks like the correct replacement head pin for your Solera Awning is the # LC266141. This will work as a replacement for your Solera Awning Idler Head # LC672052. Check out the video linked below for more details on this product.

If you have a different model idler head, let me know and I can help you find the correct replacement head pin.

expert reply by: John R

0

click to enlarge

Answer 1

We have the low profile, semi-recessed Glantastic LED RV Puck Light, #328-K-58L34P9. You do not mention what the dimensions are on your current Jupiter lights, I searched online and from what I was able to find think they may be a similar 4-1/4"…

view full answer...

Answer 2

Yes the pin part #LC266141 is the correct replacement pin for your Solera slim.

view full answer...

Answer 3

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

view full answer...

Answer 4

To reset the Furrion thermostat you basically need to cut power to it for several minutes. Here's what Furrion recommends for the reset process: Step 1: Turn The Thermostat to “Off” Step 2: Reset The Breaker. ... Step 3: Wait 30 Minutes. ... Step…

view full answer...

Answer 5

Hey Deneena, If the wall thermostat needs to be reset that frequently then it's either defective or you have some sort of power issue. There's the possibility that while you're gone if there's other campers pulling from the same grid…

view full answer...

Answer 6

In order to remove the old retaining pin from the drive pin on your Solera awning you will first need to remove the cover. The Drive Head Retaining Clip #LC266137 slides into the groove on the Drive Head Pin for Solera Power RV Awnings #LC266141. You…

view full answer...

Answer 7

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

view full answer...

Answer 8

I attached a picture of what the wax screws look like for the Solera awnings like of the #LC289561 instructions that you referenced. Basically it's under the black cap that you'll pop off and you'll unscrew that you see in the second…

view full answer...

Answer 9

Not quite, there is an additional screw below the wax screw in the end cap that also must be removed on the Solera Power Awning Idler Head #LC672052. From here you can remove the roll tube from the drive head. After the drive head is removed, there…

view full answer...

Answer 10

The Replacement Mounting Hardware part #LC701665 comes with the Extension Rods, Extension Rod Bracket, Torsion Arm Caps, and various hardware. I am not sure what all you have now but it sounds like you might also need the torsion heads, part #LC87FR…

view full answer...

Answer 11

Thank you for the picture, I can see the pin is bent rendering your solera head shaft inoperable even though you tried bending it back. Unfortunately, the only fix would be to completely replace the head as this part isn't currently available…

view full answer...

Answer 12

You are correct. The Replacement Head Pin for Solera Power Awning Gear Drive Head #LC93FR is the exact replacement for the bent pin on your Solera awning.

view full answer...

Replacement Head Pin for Solera Awning

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching