Correct Bearing Buddy Bearing Protectors for 1.940" Hub Bore
Updated 10/08/2020 | Published 10/06/2020
Question:
My hub ID appears to be 1.940”. Bearing buddy with a dia of 1.980” is too tight. Is there a bearing buddy that would fit easier on my hub? Thanks,
asked by: David S
0
Expert Reply:
Yes, the Bearing Buddy Bearing Protectors part # BB1938 are designed for a 1.938" hub bore so if you measured 1.940" this is what you'll want to use.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1938 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.94 Inch
- 2000 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Q&A: Locating OEM Brake Controller Plug On 2024 Chevy Silverado 2500
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Q&A: Recommended Stabilizer Jacks for a Rpod Trailer
- Q&A: Replacement Seals for a Jet Ski Trailer Using L44649/L44610 Bearings
- Q&A: Looking For Disc Brake Conversion Kit For 2023 Alliance 295MK
- Q&A: Can I Upgrade 7K ABS Dexter Brakes to 8K Dexter ABS Brakes For Trailer With Tow Assist?
- Article: Most Popular Wheel Bearings
- Article: Trailer Lighting Requirements
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision