Mounting Hole Dimensions of 400 Watt Go Power Industrial Pure Sine Wave Inverter
Updated 10/06/2020 | Published 10/05/2020
Question:
Hi there, This is regarding the above listed part. Is there an chance you have the dimensions of the mounting holes on the base of the inverter.
asked by: Ryley M
1
Helpful Expert Reply:
The mounting holes on the Go Power Industrial Pure Sine Wave Inverter part # 34282693 are 4.6" long x 5.9" wide. I have attached a photo to assist with this.
expert reply by:
Conner L
1
click to enlarge
Product Page this Question was Asked From
Go Power Industrial Pure Sine Wave Inverter - GFCI - 400 Watt - 24V
- RV Power Inverter
- Pure Sine Wave Inverter
- Small Appliances
- 24V
- 400 Watts
- Inverter Function Only
- AGM
- Gel
- Lead Acid
- Lithium
- Outlet
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Fuse and Breaker Locations on Lippert Power Stabilizer Jack for Forest River Trailer
- Q&A: Does Dometic FreshJet 3 Lower Vent Assembly DMC79ZR Have Thermostat
- Q&A: Installation Instructions For The Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch
- Q&A: Upgrading From WF-600 TH-112 Power Inverter To Progressive Dynamics Power Inverter
- Q&A: Recommended AC Unit to Replace a Older Dometic 13,500 BTU Unit
- Article: Steel vs. Aluminum Ball Mounts
- Q&A: Parts Needed To Connect A Dometic Penguin II Rooftop AC Unit To An iN-Command System
- Q&A: Will Dometic FreshJet 3 Air Distribution Panel work with Advent Air AC Unit
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4-Step Guide to Installing RV Solar Power