Wire Gauge to Use When Installing Progressive Dynamics Converter In RV
Updated 08/18/2020 | Published 08/13/2020
Products Featured in This Question
Question:
What is recommended feeder wire for this unit, from receptacle to unit.
asked by: James R
0
Expert Reply:
10 gauge wire like # 10-1-1 for all of the main power circuits for the # PD4575K18LS8 would be great. When in doubt though 8 gauge will work great too. Especially when making longer runs. Also I recommend having a qualified electrician at least look over the install.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Progressive Dynamics 4500 Series Inteli-Power Converter - 75 Amp
- RV Power Converter
- Converter Only
- Battery Mode Switch
- 12V
- 75 Amps
- AGM
- Gel
- Lead Acid
- Lithium
- Multi-Stage Charge
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: SmartPlug RV Power Inlet and Connector - 50 Amp - Gray
- Shop: SmartPlug RV Power Inlet - 50 Amp - Black
- Q&A: Replacement Converter For Progressive Dynamics PD4575K18L
- Q&A: Electrical Panel Box With AC To DC Converter For RV / Cargo Trailer Remodel
- Q&A: Do You Have to Replace the Converter Section of a PD4590 Power Center For Lithium Batteries
- Q&A: Recommended AC/DC Distribution Panel And Charger For A 2006 Forest River Sierra Sport T34SP
- Q&A: Upgrading To Lithium Batteries In RV - Do I Need To Replace Power Center Or Converter?
- Q&A: Recommended Replacement For A MagneTek 6345A Power Center Converter
- Q&A: Recommended Replacement Air Conditioner for RVP 8000 Series Model 8333A871
- Article: Trailer Wiring Diagrams
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: What Is Flat Towing and How to Ditch the Trailer
- Article: Steel vs. Aluminum Ball Mounts
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Sidewinder with Rotating Turret for Short Bed Pickups