Does Switch of LED Adjustable Reading Light Also Control USB Port
Updated 07/01/2020 | Published 06/24/2020 >
Question:
Does the switch that controls the light also control power to the USB port, or is the USB port always able to be used? And, if the USB is always available, does it parasitically draw a small amount of power even if nothing is plugged into it?
asked by: MICHELLE D
0
Expert Reply:
The USB port of the # CE46FR is actuave at all times and the switch does not affect it. The port being active does not draw any amperage when idle too.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
12V RV LED Reading Light - 6-1/8" Tall - Satin Nickel
- RV Interior Lights
- Reading Light
- Bright White
- On/Off Switch
- Surface Mount
- LED Light
- 12V
- Nickel
- Command Electronics
more information >
Continue Researching
- Q&A: Does The Thetford C224CW Cassette Toilet TH29UE Come With Outside Panel For Installation?
- Q&A: Can Victron Smart Solar Charger 100/30 Replace Furrion MPPT
- Q&A: High Low Adapter For Dirt Bike Carrier
- Q&A: Can Patriot Hitches Adjustable Drop Hitch Adapter Hold Motorcycle Carrier And Flat Tow Jeep
- Q&A: Goodyear Endurance or Kenda Karrier ST205/75R14 Tire for Boat Trailer at Higher Highway Speeds
- Article: How to Determine Tire/Wheel Diameter
- Q&A: Does the 30 Amp Go Power PWM Solar Charge Controller GP76QR Display Watts Produced?
- Q&A: Recommended 72" Wide RV Couches w/ a Bed
- Article: Holiday 2025 | Best Gifts for RVing
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Lighting Requirements
- Article: Which RV Propane Tank Size Do I Need?
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps


Carmen M.
6/27/2020
I recently bought two of these lights but cannot figure out how to get them to turn on. I watched the review video that shows just pushing the button, but nothing happens when I do that. Does the white plastic disc have to come off somehow to make the button work? Am stumped at to why they won't turn on. Please help!