Troubleshooting Auto Level of Ground Control RV Leveling System

Updated 06/23/2020 | Published 06/21/2020

Question:

What’s wrong? Level system will go into the program mode control is off pressed front 5 times then rear 5 times

asked by: Gary B

Expert Reply:

To achieve a successful auto level with the Lippert Ground Control part # LC358590, you want to make sure you are trying to auto level on even ground. If you are trying to auto level on uneven ground you will have to relocate the trailer before trying. You may need to reset the zero point as well. If the zero point somehow got changed or was set incorrectly then the auto level feature will not work. The zero point is the programmed point that the trailer will return to each time the auto level feature is used. I have attached installation instructions to show you how to re-calibrate the zero point.

If the auto level sequence does not perform as described, then place the system in manual mode and test the jacks operations individually to make sure they operate properly. For example: press the front button to make sure it operates only the front jacks. The front, left, right and rear buttons activate the jacks in manual mode. If one of the jacks is not operating properly, it may need to be replaced.

expert reply by: Jameson C