Can MaxxAir MaxxFan Plus Roof Vent # MA00-04751KSX Replace 4951KS

Question

Question:

Will this fan Replace a MAXXFAN 4951KS on a 2015 Montana 36RL 5th wheel.

asked by: Mark

0

Expert Reply:

Yes, the MaxxAir MaxxFan Plus Roof Vent # MA00-04751KSX that you referenced would easily replace the MaxxFan you currently have installed in your 2015 Montana 36RL as this fits the same size RV roof opening.

expert reply by: Jameson C

0

Answer 1

You will definitely be able to install the MaxxAir MaxxFan Plus Roof Vent w/ 12V Fan #MA00-04751KSX on your 2015 Lance 1052 truck camper just fine. Basically anybody that measures 14" or 14-1/4" for a vent has the same vent dimensions.…

view full answer...

Answer 2

I have done a few flat-tow setups myself and can admit they do take time. The Jeep Wrangler luckily is one of the easier vehicles to install flat-towing components on, the base plates in particular because you don't have to make any major…

view full answer...

Answer 3

Since the 2019 Chevy Colorado ZR2 comes stock with 4-wheel drive, I confirmed with your owner's manual that you can definitely flat-tow your vehicle with all four wheels on the ground behind your Leprechaun. In order to do this, you need a base…

view full answer...

Answer 4

We have a white MaxxFan vent roof with power lift and fan with the part #MA00-04751KSX which also does not have a ceiling garnish.

view full answer...

Answer 5

Yes you are correct the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is the right replacement and measures 18 1/8" long and 16 1/2" wide, which is the same measurements as your current MaxxFan Plus Roof Vent w/…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Paul, yes we do. You can use the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX to replace your current fan and will work with your original controller and garnish.

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

Actually the type of roof vent cover you need to attach to the vent cover brackets of your Maxxair 4951KS like part #MA00-04500K is the part #MA00-955003 which uses those brackets with the included cotter pins of the cover.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hey Devon, does your RV roof vent wall control unit look like the #MA59FR? If so you have a MaxxFan Plus RV roof vent that was designed for wall control and for a replacement unit you would want the part #MA00-04500K to use a setup that would use…

view full answer...

Can MaxxAir MaxxFan Plus Roof Vent # MA00-04751KSX Replace 4951KS

Product Page this Question was Asked From

Continue Researching