Troubleshooting Ground Control Leveling System Control Panel
Updated 07/09/2020 | Published 06/12/2020 >
Question:
I turn the battery on and the touchpad keeps beeping error then it goes to press enter to acknowledge. When I press enter nothing happens nor does hitting the power button its like its not even connected to the system anymore. when I went back to get pictures it didnt do anything. Not even hitting the power button. Really hoping its the touchpad thats listed in this blog.
asked by: Michael A
Expert Reply:
Often an issue like you stated has to do with the battery not being fully charged. If the battery is even slightly low, sometimes this system is a little finicky. I recommend first charging your battery fully and testing it to ensure it is fully charged then if you have the same issue, I'd replace the panel with the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System # LC421484.
Product Page this Question was Asked From
Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Controllers
- Control Panel
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Q&A: Looking for Replacement Control Panel for Lippert Ground Control 6 Point
- Q&A: Will the Dometic RV Water Heater # DMC33RR Fit in Place of My Suburban SW6DE?
- Q&A: Looking for Replacement Control Panel for Lippert Ground Control 3.0
- Q&A: How To Test for Bad Controller on Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Country of Origin For The Replacement Control Panel # LC421484
- Q&A: Troubleshooting Comm Error Check Wiring Code On Lippert Ground Control 3.0
- Article: Trailer Wiring Diagrams
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: How to Measure for Trailer Hitch Drop
- Article: Can You Flat Tow a 2025 GMC Yukon?
- Article: What Do I Need To Tow A Trailer?
- Article: Stability Control for Heavy Duty Vehicles
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs




Wynanda S.
7/5/2020
First time out with new trailer, goes great till time to store trailer. When camping it was plugged into shore power, battery shows full, we left the batteries connected, so they would continue to charge. We unhitch it, the front levelers are up. We then try to auto level it, and we get an error - low voltage. How can we have a low voltage error, when it is still plugged into the truck. I had turned off the frig, no lights were on. Nothing plugged in. Are my batteries bad - we have two 12 volt batteries. Is it the LCI 6 leveler? Not sure what to do, it is on the front ones only, the other 4 "legs" are not down. How do I charge the battery while it is in storage?