Adco Designer Wheel Covers to fit Size 225/80/22.5

Question

Question:

Sorry you have the wrong size. I need Adco "OS" size. To fit 43 - 45 inch tires. Do you have this size? It sounds like Jameson C. Is just an automated service, because answer wasn't even close. Do you have the OS size designer wheel covers or not?

asked by: Greg K

0

Expert Reply:

Whats the diameter of your tires or the size stamped on the sidewall? I am sure we have covers that would fit and work great but I need more info.

expert reply by: Jameson C

0

Greg K.

5/15/2020

Tires are 225/80/22.5 Adco size is OS fits 43 to 45" Need anything else?

Jameson C.

5/15/2020

I looked up the diameter of your tire size and found that it's 36-2/3 inches so for an Adco Designer series wheel cover you'd want the part # 290-3960. These come with everything needed to install.

Greg K.

5/15/2020

Sorry you have the wrong size. I need Adco "OS" size. To fit 43 - 45 inch tires. Do you have this size? It sounds like Jameson C. Is just an automated service, because answer wasn't even close. Do you have the OS size designer wheel covers or not?

Jameson C.

5/15/2020

The part number for what you are requesting is part # 290-3966. This is the 43 to 45 inch size you are wanting. Your tire size of 225/80-22.5 is much smaller though at 36.667 inches so the covers will fit loosely. I calculated the number again to be sure and also checked tire diameter calculators online.

Answer 1

Your tire diameter is 37-1/2 inches which means the Classic Accessories RV Wheel Covers #CA80087 would fit since it has a range of 37" to 41".

view full answer...

Answer 2

The standard wheel straps which come with the Demco Kar Kaddy SS Tow Dolly #DM9713045 are going to fit a tire up to 28" diameter. We do have the Large Strap #DM03528-93 you can order 2 of if your tires are larger than 28". If you tell me…

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 5

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 6

Good question, Dave. The easiest way is to match the RVpaws kit to your jack leg or leveling system. For example, there are specific kits for the brands and lineups out there: Standard 2" round jack leg = #RV57FR Standard 2" square jack leg…

view full answer...

Answer 7

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 8

Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…

view full answer...

Answer 9

Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…

view full answer...

Adco Designer Wheel Covers to fit Size 225/80/22.5

Continue Researching