Will Valterra Keyed Entry Door Knob Fit a 1986 Wilderness Trailer
Updated 04/21/2020 | Published 04/20/2020
Question:
Will this fit a 1986 Wilderness trailer?
asked by: Tommi B
Expert Reply:
It is possible the Valterra Keyed Entry Door Knob w/ Interior Lever for RVs - Stainless Steel part # L32CS000 will fit the 1986 wilderness trailer. The only way to know for sure is to measure the door you want to install the knob in. The door needs to be 1-3/8" to 1-5/8" thick. It also needs to have 2-3/8" to 2-3/4" from center of the face hole (where the lock installs) to leading edge of door for the locking mechanism to work properly. If your door fits these measurements the Valterra door knob will work well for you.
Product Page this Question was Asked From
Valterra Keyed Entry Door Knob w/ Interior Lever for RVs - Stainless Steel
- RV Door Locks
- Entry Door
- Door Knobs
- Keyed Unique
- Silver
- Valterra
more information >
Continue Researching
- Q&A: What To Do If Old AC Unit Is Hardwired Into Camper And Does Not Have A plug?
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Q&A: Can 3" Wide Continuous Hinge - 6' Long - 3/8" Pin Diameter Be Cut Down
- Q&A: Replacement Door Knob Needed for a 1995 Jayco Pop Up Camper
- Q&A: Which Is Better, The Curt A-Series Or Q-Series Fifth Wheel Hitches
- Q&A: What Are The Differences Between The Curt Q24, Q25, And A25 5th Wheel Trailer Hitches
- Q&A: How To Wire Brake Buddy Battery Charger 39339
- Article: Performance Chips and Modules
- Article: Trailer Tire Sizing
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Converting Your RV Water Heater to Tankless
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Repair an RV Roof