What is the Distance Between the Mounting Hole on the CE Smith Offset Spool Roller Assembly
Updated 05/22/2012 | Published 05/21/2012
Question:
I need a spool roller like the one shown for a 3 inch tongue. The mounting holes need to be at least 3 1/2 inches apart on center
asked by: George M
Expert Reply:
I pulled a CE Smith Offset Spool Roller Assembly # CE32150G that you referenced to measure the mounting holes and found that it measures 4-1/16 inches from the end of one slotted mounting hole to the end of the other. You should have no problem using mounting holes that are 3-1/2 inches apart.
Check out the video I attached if you want to see me measure the distance between the mounting holes.
Product Page this Question was Asked From
CE Smith Offset Spool Roller Assembly for Boat Trailers - Galvanized Steel w/ Black Rubber - 5"
- Boat Trailer Parts
- Rollers
- Spool Roller
- Rubber
- 5 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Can the CE Smith U Bolt # CE15253A Be Used to Mount the CE Smith Offset Spool Roller # CE32150G
- Q&A: What Does Brown and White Wire of Trailer Wiring Run To
- Q&A: Does Titan Brake Line Tee Secure Trailer Brake Lines
- Q&A: Recommended Keel Roller For Best Weight Capacity on Boat Trailer
- Q&A: Self Centering Keel Roller for Tracker Trailstar Boat Trailer
- Q&A: 60 Inch Boat Trailer Guide-Ons for 3-1/2 Inch Frame Fit
- Q&A: Recommended Front-Mounted Trailer Hitch Receiver For A 2019 Ford F-250
- Article: Boat Trailer Guides: Which are the Best?
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Determine Tire/Wheel Diameter
- Article: Best Boat Trailer Jacks
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern