Will the Pollack 7-Way Trailer End Connector Fit on a 2009 Honda Ridgeline
Updated 05/08/2012 | Published 05/05/2012 >
Products Featured in This Question
Question:
Will this item fit the 2009 Honda ridgeline?
asked by: Ravin
Expert Reply:
As long as your 2009 Honda Ridgeline has a 7-Way vehicle end trailer socket that looks similar to part # PK11893, then the Pollak 7-Way Trailer End Connector, # PK12706, will connect to your vehicle.
The connector that you referenced is the trailer side connector and should be connected to the wires on the trailer. I have attached a trailer wiring article for you to check out that will help when installing the 7-way trailer connector on your trailer.
If you do not have a 7-way socket on your vehicle, then you will need to install the 7 and 4 Way Installation Kit, # ETBC7. This kit will provide you with the 7-way connector at the rear of your vehicle.
The ETBC7 kit will require you to have a 4-way connector at the back of your vehicle. If you do not have a 4-way connector, then you will need to install the T-One Vehicle Wiring Harness, # 118400, before you install the ETBC7 kit. I have attached the installation instructions for installing this wiring harness on your vehicle.
I have also attached a video of our technician installing a the ETBC7 kit and a T-One wiring harness on a Honda Odyssey. The vehicle is different from yours, but it should give you an idea how they install.
Product Page this Question was Asked From
Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How To Plug 1997 Lance Truck Camper Into 7-way Connector On 2016 Ford F-250
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Is There a Weld Pattern for the Sleeve-Lock A-Frame Trailer Coupler # CA-5296-B?
- Q&A: Recommended Replacement for Model 70LP Surge Brake Actuator
- Q&A: Looking For Brakes And Hubs For 10K American Axles
- Q&A: When to Replace Dexter Nev-R-Lube Bearings
- Q&A: Wiring An Electric Trailer Tongue Jack Into 7-Way Vehicle Trailer Connector
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Lighting Requirements





