Will The DeeZee Specialty Series Trailer Tongue Tool Box Hold Propane Tanks

Question

Question:

DeeZee Specialty Series Trailer Tongue Toolbox - A-Frame - Plastic - 6 Cu Ft - Black Item # DZ91717P Will this box accept two 20-lb propane tanks and allow the lid to close? The specs say that the box is 17.75 inches tall and the propane tank is 17.8 inches tall. Also need 12x24inch space internally to accommodate the tanks. Thanks

asked by: Michael L

0

Expert Reply:

I have a solution for you, but since you require a minimum of 12" x 24" to store these propane tanks, I don't believe that the DeeZee Specialty Series # DZ91717P is going to work for you since it's only 18" wide at the front of the box.

I think the best solution to store your propane tanks is going to be the UWS A-Frame Trailer Toolbox # UWS01039 which has 21" of internal height and 24" at the front in order to provide you with sufficient room to store multiple propane tanks. This is an aluminum, diamond plate design that will provide you a lightweight and more secure location to store your tanks on your A-frame trailer.

I've attached a brief video review of this product to help show you a little bit more about it, as well as a picture that gives the measurements of the box.

expert reply by: Erik B

0

click to enlarge

Answer 1

Thanks for the picture! A standard 20 lbs propane tank is just under 18" tall so the DeeZee Specialty Series Trailer Tongue Tool Box item #DZ91717P is not going to work because it is only 17" tall. A standard 20 lbs propane tank is…

view full answer...

Answer 2

We have seen people mount storage boxes on either side of the nose of a V-nose trailer like what you see in the picture I attached. The part #DZ91717P would work well if you have room for it like that. The dimensions of the box are 36" long…

view full answer...

Answer 3

Hello David, Since your 2025 F-450’s 60 mm measurement from the top of the axle to the top of the bump stop unfortunately puts you outside the range Firestone designed the F95FV Red Label kit for. Firestone only supports that kit when the measurement…

view full answer...

Answer 4

Hey Jeffrey, I was able to confirm that your Dexter axle is a 3,500 lb capacity axle so the correct bearing kit would be the Dexter kit part #DX76ER. Are you wanting to have a spare set on hand or did your bearings go out?

view full answer...

Answer 5

The only sort of protection we offer for wire leads such as those on the 25 Ft 5-Way Trailer Wiring Harness part #A25W5B would be wire loom, the 3/8" Diameter Wire Loom part #39035. This can be used to cover the length of wire on the tongue or…

view full answer...

Answer 6

Since you have an aluminum trailer I suggest using a tie-down that has a backing plate like #RR5K. This will help reinforce the tie-down since aluminum may not hold up. It would be even better if you can install the tie-downs to the frame of the…

view full answer...

Answer 7

We do have a couple of options to replace your Atwood 36636, and you can use either, with the only difference being the color: - RV Propane Gas and Carbon Monoxide Detector - Black #RS54FR or White #RS34FR Either will work perfectly as replacements…

view full answer...

Will The DeeZee Specialty Series Trailer Tongue Tool Box Hold Propane Tanks

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching