Dimensions of Command Hot Line LED 328-003-6017R Third Brake Lamp Light Bar

Question

Question:

The website shows the width as 1-1/2” in one place and 1-1/4” in another. I can only use 1-1/4 in my application. Can you tell me the correct width?

asked by: Dennis

1

Helpful Expert Reply:

When mounted horizontally, the Command Hot Line LED # 328-003-6017R Third Brake Lamp Light Bar measures 1-1/4 inch in height, as shown in the provided photo. The lamp is 15-1/4 inches long in total, with mounting holes that are 13-13/16 apart, 1-1/4 inches tall and 1/2 an inch thick.

If you click the provided video, you can see a product description video featuring this lamp.

expert reply by: Mike L

1

click to enlarge

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hey Sheila, thanks for reaching out. For your 2011 Ford F-150 XLT I recommend the K-Source Snap & Zap Custom Towing Mirrors #KS81810. These are custom fitted for your truck and they slip over and snap on to the existing mirrors. They have a nice…

view full answer...

Answer 8

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

view full answer...

Answer 9

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Dimensions of Command Hot Line LED 328-003-6017R Third Brake Lamp Light Bar

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching