How Does the Curt Trailer Hitch Install on a 1997 Toyota RAV4

Updated 03/20/2012 | Published 03/19/2012

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(136)

$234.53

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2620)

$16.53

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2620)

$18.47

Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K

(2328)

$33.46

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(32)

$43.70

Pin and Clip for 1-1/4" Hitches - 1/2" Diameter

(895)

$11.49

Question:

my muffler is on the drivers side, there are hooks hanging down one on each side is that where the hitch gets bolted to?

asked by: Tom

Expert Reply:

The Curt trailer hitch, # C13524, will bolt to existing holes in the frame of your 1997 Toyota RAV4. The frame has existing weldnuts inside the frame that the hitch hardware will bolt to. I have included a link to the installation instructions for you.

On a vehicle that has seen at least one winter or is older, you will probably have grime and corrosion build up inside the weldnuts. I have included some links that will explain how to clean them out for hitch installation.

If you plan on towing, the correct ball mount is # 3593 and you can use pin and clip # PC2. For a 1-7/8 inch ball use # 19256 and for a 2 inch use # 19258. For trailer wiring use # C55486.