Troubleshooting Ground Problem On Trailer
Updated 09/05/2019 | Published 09/04/2019 >
Question:
Hello, i ran a new wire harness bought new lights, ran the green and brown down the right side the yellow and red down the left side, color matched my wires to harness from the light and secured, my trailer is aluminum my ground wire white is secured to the tongue which is steel. my trailer lights i attached to a steel bracket and fastened securely to wood top frame. I turn my hazards or blinkers on and they are really dim on the left side and nothing on the right side. then just trying to figure it out i put a steel plate from the plate the light is attached to to the aluminum frame and the light goes super bright and works properly but nothing on the right, i do the same thing to the right and nothing works either. what in the heck am i doing wrong...........
asked by: Tim
Expert Reply:
What you describe sounds an awful lot like a ground problem. Aluminum trailers are sometimes finicky about the ground connections, and because you're going from steel to aluminum to wood back to the steel bracket the fact that it doesn't sound like you have a good continuous ground ls likely your problem. In addition to grounding the trailer lamps to the frame, I'd run a continuous jumper back to the main ground on the trailer tongue. This way, everything is tied together for certain. I'll link you to a couple of our trailer wiring help articles.
Product Page this Question was Asked From
Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: 2-1/2" Hitch Receiver Extension that Reduces to 2" Receiver
- Article: Trailer Wiring Diagrams
- Q&A: Can Oil Cap RG04-230 be Used as Grease Cap
- Q&A: Way To Protect 7-Way Pins When The Door/Flap Has Broken Off
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Do You Know the Difference Between a 11033 Hub and My 11033L Hub?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Flat Towing Parts for a 2026 GMC Sierra 1500
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Replacement Connector for a Pollak PA66-MD40
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller Installation: Starting from Scratch
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne



