Cutout Dimensions for Furrion RV Refrigerator # FCR14ACBQASS

Question

Question:

What is actual cut out size needed?

asked by: Robert E

0

Expert Reply:

The cutout dimensions for the Furrion RV Refrigerator # FCR14ACBQASS are 72-11/16 inches tall, 31-3/4 inches wide, and 22-13/16 inches deep. I have attached a diagram from the install manual that you can use for reference as well.

expert reply by: Chris R

0

click to enlarge

Answer 1

The correct replacement for a Power Gear Above Floor Slide Out Motor 368807 is the Replacement Gear Motor Assembly DSMX with P Connector for Lippert Slide-Out part #LC368190.

view full answer...

Answer 2

I was able to find the 126003 hub and was able to determine that it is a 3,500 lb hub/drum with a 5 on 4-1/2 inch bolt pattern just like the #AKHD-545-35-K that you referenced. This hub will work as a replacement for your Lippert.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Cutout Dimensions for Furrion RV Refrigerator # FCR14ACBQASS

Continue Researching