Receiver Height of Curt Class III # 13650 When Installed on 2009 Ford Escape

Updated 03/08/2012 | Published 03/06/2012

Products Featured in This Question

Convert-A-Ball Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10,000 lbs

(1363)

$80.25

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(542)

$239.82

1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs

(2634)

$11.68

etrailer Trailer Hitch Receiver Lock for 2" Hitch - Flush - 2-5/8" Span - Stainless Steel

(1318)

$34.22

Question:

I plan on ordering the Curt trailer hitch # 13650 for my 2009 ford escape plus the wiring accessoies, would you know if there is a predetermined hitch height from the ground to the top of the receiver for this set up. Im trying to firure out the correct ball mount and I have the boat trailer coupler height, I would like to be able to order a ball mount with every thing but it has to be right. Thank You

asked by: Michael R

Expert Reply:

Assuming that your Escape uses a stock wheel/tire, the top of the receiver for the Curt # 13650 would be 16 inches above the ground.

Getting the trailer to tow so that it is level is not an exact science. If you can get it within 1-1/2 to 2 inches of level, you are doing just fine. It is better to have the coupler height a bit higher than level than lower.

In addition to the hitch, wiring harness and ball mount, you might also need the following:

Pin and clip, part # PC3
Locking stainless steel hitch pin, part # e98882
1-7/8 inch trailer ball, # 19260
2 inch trailer ball, part # 19247

I have provided links to the install instructions for the hitch and the wiring harness, as well as links to install videos that you might find helpful.