Flashing Middle Light on Lippert Ground Control Leveling System
Published 08/02/2019
Question:
I was wondering if the middle light on the LCI electronic leveling keeps flashing how do you get it to reset
asked by: Dennis
0
Expert Reply:
The flashing error code on your Lippert Ground Control System # LC358590 can be manually cleared out by holding the retract and enter buttons at the same time. This should hopefully reset the unit so the flashing light goes away and the jacks go back to proper operation.
If this does not resolve the issue please let me know and I will be happy to look into this further.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: How Can I Lock My Watchdog Power Center Surge Protector and Voltage Booster to Pedestal?
- Q&A: Will Turn Signals Activate Side Cameras of Furrion Vision S+ System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Do Lithium Batteries Need to be In Different Compartment from Inverter
- Q&A: Lippert Ground Control 3.0 Leveling System For A Prepped Forest River Wolf Pack 315PACK12
- Q&A: Replacement Control Module for Lippert Ground Control 3.0
- Q&A: Non-Combustible Backing Board Needed For Mounting A 3,000 Watt Inverter
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices