Trailer Wiring to Fit Gray Connector of 2011 Honda Pilot At Rear of Vehicle
Updated 06/04/2019 | Published 06/03/2019
Products Featured in This Question
Question:
I bought my 2011 Pilot new and it has a hitch but no plug. I brought to Honda and they showed me that it is factory wired to witin a foot from where it should mount to the bumper. There is a gray plug zip-tied over the drivers side exhaust. Honda told me that piece is extra and coast 185.00. Ot is only 14 inches long. Would you know the part number? Honda couldnt tell me. Thank you.
asked by: Newton
Expert Reply:
Does the connector look like the matching connector to the picture I attached to this page? If so, then all you need to complete the trailer wiring is the part # 118491 for a 4-way or part # 118253 for a 7-way which are both a confirmed fit for your 2011 Honda Pilot.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Tell if a 2010 Honda Pilot has a Factory Installed Tow Package
- Q&A: Removing Wiring Harness Cap to Install # 118491 on 2010 Honda Pilot
- Q&A: What is the Differences Between TowReady T-One # 118329 and Curt # C55329 Wiring Harnesses
- Q&A: Recommended Brake Controller and Installation for 2021 Honda Passport
- Article: Rooftop Cargo Carriers
- Q&A: How the Shock Absorber Works on a Surge Brake Actuator
- Q&A: Troubleshooting Turn Signals of Trailer Wiring on 2009 Honda Pilot Not Working
- Q&A: Recommended Trailer Wiring For 2011 Honda Pilot
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?