Location of Brake Controller Connector in 2019 Subaru Ascent

Question

Question:

wHRE DO i PLUG THISIN? i HAVE THE TOW PACKGE

asked by: JOEY

0

Expert Reply:

To install the Redarc Tow-Pro Elite brake controller, part # RED44FR, in your 2019 Subaru Ascent you need to find the white connector with the standard red, white, blue, black wires coming out of it behind a kick panel to the left of the driver. The picture I attached shows the location.

Use part # 3062-P to plug into that white connector to install and use the Redarc controller.

expert reply by: Charles S

0

click to enlarge

David W.

5/20/2024

So helpful Charles! thanks! question, I do NOT have a factory installed hitch/controller, but just ordered a hitch from yall. Can I just plug in the adapter # 3062-P to my tekonsha brake controller and its good to go?

Bryce D.

5/28/2024

@DavidW Correct David! If you do have a 2019 Subaru Ascent then you can use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3062-P with the Tekonsha Prodigy P3 Trailer Brake Controller # 90195 you ordered and you'll be good to go.

Answer 1

To install a trailer brake controller on your 2014 Jeep Wrangler Unlimited with the factory tow package you will need the Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers #5506. There is not a plug and play adapter made your…

view full answer...

Answer 2

According to Tekonsha, the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers part #3062-P will fit your 2019 Subaru Ascent and allow you to use the Tekonsha Primus IQ Trailer Brake Controller part #TK90160. The plug is located underneath…

view full answer...

Answer 3

Yes, Tekonsha released the part #3062-P which is a brake controller install harness that fits your 2019 Subaru Ascent and would work well. I attached a picture that shows where you'll find it on your vehicle too. For a brake controller I would…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

I sure can Galen, and thanks for the information. Since your Tiffin motorhome has the air line connection you'll need the Demco Air Force One Flat Tow Brake System for 2020 and Newer Tiffin Chassis RVs w/Factory Air Brakes item #DM55MV. This…

view full answer...

Answer 10

Thanks for your question, Steve. Installing the Timbren Rear Suspension Enhancement System #T76FR wouldn’t eliminate the need for a weight distribution system if your setup calls for one, they actually serve two different purposes. A weight…

view full answer...

Answer 11

Not another one! Just kidding Dirk! I was in the Marines I enjoy these conversion questions on the M1101 trailers. I'd be more than happy to list the parts you need, along with quantity, and confirm compatibility. 1 - Timbren Axle-Less Trailer…

view full answer...

Answer 12

Hi Arthur, I took a look at your list of parts to flat tow your 2026 Jeep Wrangler Rubicon and it looks like you have almost everything you need! For the Blue Ox Patriot Supplemental Braking System part #BLU37TR, it plugs directly into a 12V outlet…

view full answer...

Location of Brake Controller Connector in 2019 Subaru Ascent

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching