Where Does Spindle of Timbren 7k Axle Less Install Relative to Trailer Frame
Question:
Item # TASR7KS02 According to your diagrams the axle is 3/8 off the frame with 2-1/2 travel. Is this correct? Or is there a number in front of the 3/8? On the 5k axles it is significantly different.
asked by: Dan
0
Expert Reply:
The spindle height relative to the trailer frame that the Timbren Axle Less kit part # TASR7KS02 you referenced is correct as I verified this with Timbren just now. It is -3/8 inches because this is a drop spindle setup which means the trailer is designed to sit closer to the ground.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Standard Duty - 4" Drop - 5 Bolt Flange - 7,000 lbs
- Trailer Axles
- Rubber Spring Suspension
- EZ Lube Spindles
- 7000 lbs
- Spindles Only
- Universal Fit
- Drop - 4 Inch
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Highest Capacity Timbren Axle Less Tandem Axle Setup Recommendation, Hubs, Actuator Brake Line
- Q&A: How to Determine Wheel Offset of Trailer Wheels
- Q&A: Will The SuperSprings SuperSway Stops SS65GR Work on 2022 Ford F350 With Air Suspension
- Article: Enjoy The 2024 Eclipse With Harvest Hosts
- Q&A: Recommended Hub and Drum Assemblies and Brakes for 7,000 Pound Triple Axle Trailer
- Q&A: Replacement Suspension Kit Recommendation for a 2021 Lamar Trailer with Tandem 7K Axles
- Q&A: Is It Required The Spring Seat Be Welded to Trailer Axle
- Q&A: Can 235/75-15 Trailer Tires Be Replaced With 235/85R16 Tires For Higher Load Capacity
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Survive the Winter In Your RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Rooftop Cargo Carriers