2.44 inch Diameter Dust Caps for Trailer Bearings on a Coromal Van
Updated 12/28/2011 | Published 12/27/2011 >
Products Featured in This Question
Question:
I am trying to buy a set of dust caps for my Coromal Van they are 2.44 Inch or as someone suggested 2and 7/16 Inch in size- they seem to be like hens teeth . Any help would be appreciated.
asked by: Mal C
0
Expert Reply:
We carry the TruRyde Grease Cap, # F001520, that should work for you, but you will need to make sure that the depth of the cap will work with the existing hubs on your Coromal Van.
The depth of this cap is 1.03 inches, so as long as the spindle on your van does not protrude more than 1 inch beyond the face of the hub this grease cap will work for you.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Grease Cap, 1.988" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 1.99 Inch O.D.
- 1.99 Inch
- 2000 lbs Axle
- 2200 lbs Axle
- 2500 lbs Axle
- 3000 lbs Axle
- 3500 lbs Axle
- TruRyde
more information >
Continue Researching
- Q&A: Is There Trailer Bearing Kit With Bearings L44649 & L68149
- Q&A: Replacement Tankless Water Heater for 12" x 16" Atwood Water Heater
- Q&A: Will Tie Down Side-Mount Spare Tire Mount Fit 3" Tall Trailer Tongue
- Q&A: Horse Trailer Ramp Spring For Helping Lift Heavy Ramp
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How Much Does a Boat and Trailer Weigh?
- Q&A: Recommended Replacement Converter for a Elixir ELX-45
- Q&A: Location of Brake Controller Port on 2026 Leisure Travel Unity U24MBL on Sprinter Chassis
- Article: Most Popular Wheel Bearings
- Q&A: What Are the Frame Tabs Called That a 5th Wheel Pin Box Mount to?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Mount a Truck Bed Camper

