What Size Axle Will the Kodiak Disc Brake Kit # K2HR712DS Fit
Updated 03/25/2019 | Published 03/22/2019
Products Featured in This Question
Question:
i went no if you disk break /K2HR712DS fit on axle 4 inc . thank,s
asked by: Jean
0
Expert Reply:
The Kodiak Disc Brake Kit # K2HR712DS is compatible with 7,000 lbs axles that have #42 spindles. These spindles use inner bearing # 25580, outer bearing # 14125A, and grease seal # RG06-070. All of these can be found in the bearing kit # BK3-200.
As long as your axle and spindle falls within these parameters then you can definitely use this disc brake kit.
Be sure that you are using an actuator that is compatible with disc brakes.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - Dacromet and Stainless - 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 7000 lbs
- Brake Assembly
- 8 on 6-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Grease Cap for 7,000 Lb Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Can I Use a Slip On Disc Brake Rotor with the 7000-lbs Trailer Idler Hub Assembly
- Q&A: Recommended Disc Brake Conversion Kit for a 2019 Grand Design Solitude 373FB
- Q&A: Parts Needed to Install Disc Brakes on 2019 Grand Design Solitude 310GK
- Q&A: Is There a Replacement Hub For a AL-KO 7170 Trailer Hub?
- Q&A: Availability Of Screw-In Oil Bath Cap With 2.77" ID
- Q&A: Replacement Timken Parts for 25580/15123 Bearings and 10-36 Seal
- Article: Brake Controller Installation: Starting from Scratch