Camco Olympian Wave 3 Heater Compatibility with Disposable 1 lb Propane Cylinder

Question

Question:

Can the Olympian wave 3 heater be used with the 1Lb disposable propane cans? With which fitting/hose?

asked by: Christine

0

Expert Reply:

The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs # CAM57331 can be used with 1 lb disposable tanks when you use the Camco Low-Pressure LP Gas Regulator w/ 6' Long Hose # CAM57703 and adapter # 204132-MBS or # CAM59213.

You may also be interested in using the Camco Leg Stands for Olympian Wave Heaters - Qty 2 # CAM57701 to allow the heater to be freestanding.

expert reply by: Jason S

0

Patty W.

5/19/2020

Can the 1lb propane bottle and hose be inside the RV? What about a 20lb bottle with the low pressure reg and hose in the RV?

Chris R.

5/21/2020

For safety reasons I would try to keep the tank(s) outside of the camper when the heater is in use.

Answer 1

Hey Elizabeth. Not sure how your RV is setup but you can only run one regulator per line/appliance. The Camco Olympian Wave 6 Catalytic Safety Heater for Mid-Sized RVs item #CAM57341 does not have one but if you put two regulators on the same propane…

view full answer...

Answer 2

What you need is the Camco Propane Adapter #CAM59213. This allows you to adapter a hose like part #CAM57703 that you'd use for the Wave 6 #CAM57341 to connect to a 1-lb (throwaway) bottle of propane. Attached is a quick demonstration video that…

view full answer...

Answer 3

The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs #CAM57331 can be connected to a 1lb propane tank using a hose like part #CAM57703 and an adapter like part #37207-30205. This heater can draw 1,600 to 3,000 btu's depending on how…

view full answer...

Answer 4

For the regulator you'll want to use #CAM59013 and for the Type 1 fitting that fits into the regulator you'll need part #CAM59933. You'll be able to attach to your existing hose and then use the #204132-MBS on the Type 1 fitting to…

view full answer...

Answer 5

If you will be permanently installing the Camco Olympian Wave 3 Catalytic Safety Heater part #CAM57331 then you would need to run a hose from the heater to the propane manifold. I cannot recommend you tap or splice into an existing line. The fitting…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Andrew, brand running boards that fit your 2020 Ford Transit T250 do require drilling like the part #RMK94PR. I wish there was a no-drill option but it's just not available on your vehicle as it doesn't have any brackets made for steps.

view full answer...

Answer 10

Hey Rod. The Van Windows Direct Awning Van Bunk Window item #VW74FR is a universal part so you'll need to take a couple measurements to confirm it'll fit your 2023 Ram ProMaster 3500 EXT. This window is 34-3/4" x 11-3/4" and…

view full answer...

Answer 11

Hi Tiffany; the installation time for the Romik Connect ROB-C Running Boards #RMK37VR is 120 minutes.

view full answer...

Camco Olympian Wave 3 Heater Compatibility with Disposable 1 lb Propane Cylinder

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching