Curt TriFlex Trailer Brake Controller Shows While Driving

Question

Question:

Dealer installed a Curt C24VV in my 2003 Toyota Sequoia. The controller use to illuminate a number value when I press the brake peddle. The C24VV now stays illuminated with 2 dash lines in the display. It has worked flawlessly until now. Should I have 2 dash lines? Thanks

asked by: Steve

0

Expert Reply:

If the Curt TriFlex Trailer Brake Controller part # C24VV is showing a "--" in your 2003 Toyota Sequoia while driving then this points to an issue with the power and or ground supply. I would first start off by removing the ground, sanding down the surface, and then reconnecting with new hardware/connectors. Once the ground is checked you will then need to move onto the power wire tracing it back to the battery while looking for breaks. I would also make sure the ring terminal around the positive battery cable is tight.

If both the power and/or ground are checked but to no avail then there may be an issue with the brake controller. If that is the case then you will need to contact the manufacturer or dealer that installed the brake controller as it has a lifetime warranty.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 4

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 5

Hey Brandon, I would strongly recommend sticking with the Tekonsha RF brake controller part #TK94FR. We know this works really well and it sounds like it worked well for you too. The Curt Echo is not reliable enough for me to really ever recommend it…

view full answer...

Answer 6

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 7

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

It sounds like you may already have a 4 way connector on your vehicle, which is half of the battle. In order to operate the Curt Echo Mobile Wireless Brake Controller #C51180 you will need an almost fully functional 7 way connector; using something…

view full answer...

Answer 10

Hey Jeff, thanks for reaching out. Yes, the Curt Echo Wireless Brake Controller #C51180 will absolutely work on your 2026 Ram 1500 Rebel. As long as it has the factory 7-way, the echo unit will work just fine. I'm not 100% sure why we don't…

view full answer...

Answer 11

Hey John, good question. The app must be running in order for the separate manual override button part #C83HR to work. If your phone is not connected to the controller with the app running, the button will not do anything. I know the connectivity…

view full answer...

Curt TriFlex Trailer Brake Controller Shows While Driving

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching