Is DeeZee Truck Bed Auxiliary Fuel Tank Compatible with Gasoline?

Question

Question:

Can this be used safely for a Gasoline truck?

asked by: Brandon

0

Expert Reply:

The DeeZee Truck Bed Auxiliary Tank - Rectangle - Aluminum - 38 Gallon # DZ91752X are only intended for using Diesel fuel according to my contact at the manufacturer. It would be a large liability for them to sign off on using it for gasoline because it is much more explosive than diesel fuel.

It will technically work for gasoline, but it is not recommended and would not be warrantied.

expert reply by: Jason S

0

click to enlarge

Answer 1

Hello Larry, thanks for reaching out. We do have tire covers that will fit 14" tires. Our tire covers are classified under the tire diameter instead of the wheel diameter. That said, it will help to know exactly what size your 14" tires…

view full answer...

Answer 2

Hey Ed, The Easy Grease Trailer Hub/Drum Assembly #AKHD-545-35-G-EZ-K uses grease seal #58846 and are made by AxleTek, who is not in the U.S. The Dexter Trailer Hub & Drum Assembly #84546UC3-EZ and #84546UC3 uses the same grease seal part number,…

view full answer...

Answer 3

The rollover valve that you see installed in the install video for the DeeZee Bed Aux tank part #DZ91752X is designed to prevent the tank from leaking fuel everywhere in the event of an accident where the vehicle would end up upside down. It also…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Is DeeZee Truck Bed Auxiliary Fuel Tank Compatible with Gasoline?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching