When are Isolating Diodes Required for Installing the Curt 2-Wire to 3-Wire Converter

Question

Question:

Hi, Some QnA recommend isolating diode, while others didnt specify. could you explain what kind of backfeeding and current flow path are under concern at which conditions? if you can present rough diagram inside C56196, I guess it could be helpful to clearly understand.

asked by: Thomas

0

Expert Reply:

The answer actually isn't very technical. Curt doesn't require that diodes be used with the Converter # C56196 however some Experts still like to recommend using a diode like part # RM-690 to prevent backfeed just because you are adding something different to the original wiring.

If you are connecting this to the OEM wiring on a pickup for a 3rd brake light then a diode would be a good idea, but if you are only splicing this into some trailer wiring a diode isn't necessary.

It never hurts to install a diode as that is just adding some extra protection to your other wiring.

expert reply by: Jon G

0

click to enlarge

Answer 1

If your trailer has separate turn signals from the brake lights and you want them to remain that way, you will need to use a special converter. On the trailer side, behind the 7-Way, you will attach the Vehicle to Vehicle Taillight Converter,…

view full answer...

Answer 2

Hello Jeff, Thank you so much for the pictures, they are most helpful. Yes, the Dexter Trailer Brake Drum for 12,000-lb and 15,000-lb Axles - 12-1/4" x 5" - 8 on 6-1/2 #DX34XR is the correct dexter drum to replace your Lippert Drum Drum…

view full answer...

Answer 3

I spoke to my contact at Curt and they informed me that the reason you are hearing the buzzing noise and the third brake light is flashing when using the Vehicle to Vehicle Tail Light Converter part #C56196 is because the green and yellow output…

view full answer...

Answer 4

We have a coiled 7-way to 5-way like with the part #C57271 for a 60 inch long setup. We don't have a 5-way to 5-way though so you'd have to cut off the 7-way and wire in a new 5-way like with the #HM47910.

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

Trailers use what is called a 2-wire system which means the turn signals and brake lights are on the same circuit. When you try to add separate amber turn signals you will need to separate out the brake light signal using a converter, #118158. On…

view full answer...

Answer 7

Hey Jerry, when installing the Roadmaster Brake Lite Relay part #RM-88400 the red wire runs to the running light circuit which is typically a brown wire. In the diagram it's being called the taillight circuit but that's same thing as running…

view full answer...

When are Isolating Diodes Required for Installing the Curt 2-Wire to 3-Wire Converter

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching