How Much Does the Trailair Flex Air and Rota-Flex Pin Boxes Weigh

Question

Question:

I’m right at the limit of the tow vehicle how much more does the Trailair flex air weigh, compared to roto flex

asked by: Darwin

0

Expert Reply:

The Trailair Flex Air 5th Wheel Pin Box part # LC369535 weighs around 230 lbs and the Trailair Rota-Flex 5th Wheel Pin Box part # LC328330 weighs around 100 lbs. They are both designed to replace a Lippert 1621 pin box.

expert reply by: Conner L

0

Answer 1

The Replacement Control Module for Lippert Ground Control 3.0 Leveling System #LC85ED is part of the Ground Control system that does have a wireless remote compatible with it like the part #LC358601. It is not a BlueTooth connection though.

view full answer...

Answer 2

Yes, the SumoSprings Trailer Helper Springs w/ Line Relocation Bracket #TSS-107-40 will work with both slipper and double eye leaf spring styles. Double eye springs are just more popular than slipper springs which is why all of the photos and videos…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

*Updated From Below Hi Michael; I'm sure you're right, it is probably prepped for the Furrion. Since Furrion is phasing out the old Vision S, and parts won't be available soon, you want to get the new Furrion Vision S+ Wireless RV Backup…

view full answer...

Answer 6

Hey Mike, your 2025 Chevy Silverado 2500HD will have the power issue with the Furrion Vision S + #FR57AD that you have so you would need a solution like the part #VGR64VR that you referenced. Or if you don't want to mess with any wiring you could…

view full answer...

Answer 7

Hey, Joe. That's a great question. Backup cameras and rearview, observation, cameras are essentially the same, the difference comes down to how they’re wired. With a system like the Furrion Vision S+ Wireless RV Backup System #FR57AD, it’s…

view full answer...

Answer 8

Hey Bill, yes the Furrion Vision S+ #FR64AD would be a direct replacement for your current Vision S system. None of it is backwards compatible with the standard Vision S system though.

view full answer...

Answer 9

Hey Michael. The backup camera that comes with the Furrion Vision S+ System item #FR57AD has built in mounting holes in the casing. It comes with four #6 x 3/4" flat head self-tapping screws, four #4 x 1/4" self-tapping screws, sealant, and…

view full answer...

Answer 10

Hi Eric, It sounds like you have a Furrion S Wireless Back-Up Camera System like part #FCE48TASL-05, which has a back up camera and two side cameras with integrated LED lights. The Furrion S Wireless Systems are only compatible with Furrion Vision S…

view full answer...

Answer 11

Hey Thomas, for just a single rear camera Furrion Vision S+ kit you'd want the part #FR57AD. Are you wanting an additional rear camera to use with this or the one with the red light built into it by chance? We don't have either of those right…

view full answer...

How Much Does the Trailair Flex Air and Rota-Flex Pin Boxes Weigh

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching