Parts Needed to Easily Convert 4-Way of Trailer to 7-Way
Published 09/05/2018 >
Products Featured in This Question
Question:
Hi, I recently purchased Electric brakes to replace my old corroded hydraulic setup thats has failed. Everything from a wiring perspective works great. Here is my question. It would be really difficult to replace the entire lighting system with a new 7 wire loom. Instead I want to know if I can simply run a single blue 12-16 gauge wire from the new assemblies hook LandR so only need 1 wire to the tongue and then simply purchase a new 7 PIN plug to wire in the existing 4 PIN lights, and the new Blue Brake wire. The second wire from the brake assembly is grounded to the axel tube using self tapping sheet metal screws and a connector. I can then also easily in the future run the red 12v power to a brake away, and have no need for backup lights. My only concern is if this will work appropriately. 1. Does the single Blue wire control the brakes completely? Wasn’t sure about in a backup situation? 2. The 12v power shouldn’t be needed to power the electric brakes correct? 4. Leaving the 12v, and the aux wire from the plug shouldn’t affect anything on the truck side I have a built in braking actuator. Thanks,
asked by: Christopher L
Expert Reply:
We have a kit designed for converting a trailer with a 4-way to having a 7-way. For that you'd want the # HS381-9000 which you'd wire your current 4-way to and then have the ability to easily add additional circuits like trailer brakes by wiring them to the junction box.
The single blue wire from a 7-way controls the brakes and not other circuits (besides ground) need to be ran for it to be complete. The 12 volt accessory circuit would have no affect on the trailer brakes.
Product Page this Question was Asked From
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Continue Researching
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Difference Between A35WB And A35W42B 35 ft. Wishbone 4-Way Trailer Wiring Harness
- Q&A: What Wire Gauge Is The TowSmart 16 to 18 Gauge, 4 Conductor Wire?
- Q&A: Recommended Bolt On 7,000 lbs Capacity Square Jack
- Q&A: Can A No-Drill Bracket Be Installed On A Hitch With A Square Crosstube?
- Q&A: Replacement Bearing Kit for 7K Dexter Axles 651773
- Article: Trailer Lighting Requirements
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Tester Battery Replacement for Part Number 8010
- Article: How to Measure Your Trailer Wheel Bolt Pattern

