Dimensions for etrailer.com Landing Gear Set # RVLG-8000

Published 08/22/2018

Question:

What is the dimension from the center line of the crank handle shaft to the bottom of the upper weld stop? What is the dimension from the center line of the connecting shaft to the same spot on the weld stop? My camper is old enough that it doesnt have a reducer gearbox, the shaft runs straight through the first landing gear leg and straight through the frame on the outside. I think anything I do here is going to require some fabrication. Also, Im assuming these are 2-1/2inch upper tubes? Thanks,

asked by: Charlie W

Expert Reply:

I went out to our warehouse so I could take a couple measurements on the etrailer.com Landing Gear Set # RVLG-8000 referenced in your question. From the center of the cross shaft to the bottom of the top weld stop I measured a distance of right at 7 inches. From the center of the crank handle shaft to this same location there is a distance of 9-1/2 inches. The outer leg tubes are indeed 2-1/2 inches x 2-1/2 inches.

I have attached an image with these dimensions labeled that you can also check out.

expert reply by: Chris R