Can an A-Frame Trailer Jack Be Rotated for Clearance
Updated 07/30/2018 | Published 07/28/2018
Products Featured in This Question
Question:
Can the release pin on the collar be mounted to the side instead of to the rear.? I have a winch for my pop up directly behind he jack.
asked by: Joel
Helpful Expert Reply:
Yes, you can mount the Ultimate Trailer Jack part # 322-RDJ-2K so that the release pin faces outward instead of towards the trailer. All you need to do is rotate the jack until the mounting holes line up and the pin is pointed away from the trailer. This should in turn give you the clearance you are looking for.
If you would like to add a foot pad to this jack then you can use part # JF-101BK which is a direct fit.
Product Page this Question was Asked From
Ultimate Trailer Jack - A-Frame - Topwind - 15-1/2" Lift - 2,000 lbs
- Trailer Jack
- Utility Trailer
- A-Frame Jacks
- Topwind Jack
- 1001 - 2000 lbs
- Manual Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Low Profile Trailer Jack Recommendation for Better Tailgate Clearance
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Can I Install the Square A-Frame Jack w/ Footplate e74VV in a Round A-Frame Hole?
- Q&A: How To Stop A-Frame Jack From Scrapping Ground While Going Over Bumps
- Q&A: A-Frame Coupler and Trailer Jack With Caster for Boat Trailer
- Q&A: How Does The Ultimate Trailer Jack Fold Up For Travel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Jacks
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Article: Trailer Wiring Diagrams
- Article: Spring Towing Readiness Checklist
- Article: Brake Controller Installation: Starting from Scratch
- Article: How Much Solar Power Do I Need For My RV?