What is the Height of the Chocks That Come with the PackEm Wheel Tie-Down Kit # PK-WTD
Updated 07/16/2018 | Published 07/13/2018
Question:
NOT sure if my rear engine riding mower would drive OVER these, what is the measurement from the base where they bolt to a surface TO the top highest point? This will help me determine if MY mower can pull over them.
asked by: Numa
Expert Reply:
If you want to mockup a trial run to see if your lawn mower can get over the Pack'Em Wheel Tie-Down Kit # PK-WTD then you need something that is 7" wide x 5-5/8" long x 1-5/8" tall. The height of 1-5/8" is from the mounting surface to the highest point of the chock so your test item would need to be at least that high.
Product Page this Question was Asked From
Pack'Em Wheel Tie-Down Kit for Truck Beds and Trailers - 30" Tires - 800 lbs
- Car Tie Down Straps
- E Track Ends
- 6 - 10 Feet Long
- Wheel Net
- 1500 lbs or Less
- PackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Can I Replace a Dometic 301 Toilet w/a Dometic 411 RV Toilet?
- Q&A: Options For Mounting A Spare Tire Under The Tongue Of A Trailer
- Q&A: Recommended Hardware for Erickson ATV E-Track Tie-Down Kit
- Q&A: Replacement Surge Brake Actuator for a 2012 Jayco Pop-Up Camper
- Q&A: Tow Mirror Recommendation for 2025 Toyota Tacoma
- Q&A: How to Find Correct Replacement Braking Assemblies for a 1989 EZ Loader Trailer
- Q&A: Measurements of B&W 2-5/16 Inch Hitch Ball with 1 Inch Rise
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Wiring Diagrams
- Article: How to Replace or Install an RV Roof Vent
- Article: Cargo Tie-Down Methods
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Anti-Rattle Devices