Will There Be Play Between the Ball Mount Shaft and the Hitch
Updated 09/06/2011 | Published 09/03/2011
Question:
should the shank fit snug in the hole or can there be some play in the shaft?
asked by: Michael H
0
Expert Reply:
There will be a small amount of play between the shank of the ball mount and the receiver hitch when the ball mount is installed.
If you would like to eliminate this play you can use an anti-rattle device like an Anti-Rattle Device for 2 inch Hitches # SR25219. I attached a review video for this product for you to check out also.
I attached an FAQ on ball mounts that you might find informative also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will The Curt T-Connector C56378 Work On A 2015 Honda Odyssey With Backup Sensors?
- Q&A: Distance From Center Of Hitch Pin Hole To Hitch Ball On Blue Ox Adjustable Ball Mount
- Q&A: Where is Factory Trailer Wiring Connector on 2022 Buick Envision Preferred
- Q&A: Recommended Replacement Coupler For An Atwood 2" Coupler
- Q&A: Does Rear Bumper of 2022 Buick Envision Remove to Install Curt Hitch
- Q&A: Installing Reverse Lockout Solenoid To Stop Brakes n Trailer When Going Downhill With Motorhome
- Q&A: Recommended Trailer Hitch Receiver for a 2007 MazdaSPEED 3
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Maintenance Schedule
- Article: Trailer Hitch Installation Tips
- Article: How to Strap a Kayak to a Roof Rack in 4 Steps (With Pictures)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Best Running Boards
- Article: Troubleshooting 4 and 5-Way Wiring Installations