Mounting Bolt Dimensions of Titan Bolt-On Coupler

Question

Question:

what size are the mounting bolts?

asked by: Ethan H

0

Expert Reply:

The Titan Bolt-On Coupler # T4855300 uses Grade 8 bolts that measure 6" long and have a 5/8" diameter, as you can see in the accompanying photo.

This coupler has a 21,000 lb capacity, with a distance between mounting holes of 2" center to center. It is designed to be used with 7,000 lb triple axles and is designed for a 3" wide channel bracket.

expert reply by: Kyle S

0

click to enlarge

Answer 1

The bolts that come with the Titan Bolt-On Coupler for 2 5/16" Ball - Primed - 21K #T4855300 have a 5/8" diameter, is 6" long, and have a grade 8 rating for strength (see attached photo). I've attached a review video for you to…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

First I want to make sure you verify your channel mount for the Demco Trailer Coupler #DM14040-81 has a 21K or larger capacity as often times they are less like the Demco #DM15349-52 which often times people look at and think it is a channel mount…

view full answer...

Answer 7

Hey Kris, the Dutton Lainson winch part #DL15440 does not come with a strap so you will need to order one with it. The part #DL24250 will work great with this winch as it is correct width, is 25 feet in length, and has a capacity of 3,700 lb WLL and…

view full answer...

Answer 8

Personally I prefer the Demco Trailer Coupler #DM14976-52 with the composite handle over the Coupler #DM15791-81 with a metal handle. I feel it is easier to operate as it does not have the safety latch like you get on the metal handle. Since most…

view full answer...

Mounting Bolt Dimensions of Titan Bolt-On Coupler

Product Page this Question was Asked From

Continue Researching