Width of Bulldog Replacement Pipe Mount for Swivel Jack Where it Attaches to Trailer
Updated 05/22/2018 | Published 05/21/2018
Question:
Size of weld on pipe where weld
asked by: Dickhirt
0
Expert Reply:
On the Bulldog Replacement Pipe Mount for Swivel Jack - Weld On - 5/8" Pull Pin, # BD500339, the square mount measures 2-1/4 inches wide.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Bulldog Replacement Pipe Mount for Swivel Jack - Weld On - 5/8" Pull Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- Bulldog
more information >
Continue Researching
- Q&A: Distance From Hitch Pin Center to Beginning of Drop on Draw Tite Ball Mount 40332
- Q&A: Brake Controller Installation on 2011 Toyota Tundra
- Q&A: Parts Needed and Instructions for Installing Brake Controller on a 2019 Jeep Wrangler Unlimited
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Bearing Kit Recommendation for a Dexter 2800 lb Axle
- Q&A: Recommended Replacement Seal For A Tri Tec T-23972 Seal
- Q&A: Recommended Hanger Spacing for Triple Axle Trailer
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Ram Trailer Tow Prep Package
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Couplers
- Article: Trailer Lighting Requirements
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)