Distance From Hitch Pin Center to Beginning of Drop on Draw Tite Ball Mount 40332
Updated 02/11/2026 | Published 02/10/2026
Question:
I am looking for the dimension from the center of the pin to the start of the drop. Thanks!
asked by: Robert G
0
Expert Reply:
Hey Robert, on the Draw Tite ball mount # 40332 it is 5 inches from the center of the hitch pin hole to the beginning of the drop portion of the ball mount. Do you have tight clearances or something that might hit the ball mount if it stuck out to far?
expert reply by:
Jameson C
0
Continue Researching
- Search Results: 10~51 seal
- Search Results: marker trailer lights
- Search Results: trailer breakaway kit
- Search Results: hub caps
- Search Results: 12000 jack
- Search Results: weld~on hinge
- Search Results: 8~288
- Shop: MaxxAir Standard Roof Vent Cover - 20" x 19" x 9-1/2" - Translucent White
- Video: Top Rail Trim for Enclosed Trailer Spec Review
- Shop: Even Angle Trim for Trailers - 93-1/2" Long x 1" Tall x 1" Wide
- Shop: Even Angle Trim for Trailers - 93-1/2" Long x 3/4" Tall x 3/4" Wide
- Shop: Brightway ICU Trailer Breakaway Kit w/ Charger, LED Tester, and 5 Ah Battery - Side Load
- Shop: Square 2-Speed Jack - Drop Leg w/ Spring Return - Weld On - Sidewind - 25K
- Shop: etrailer Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1,000 lbs
- Shop: etrailer Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 11" Lift - Zinc - 1.5K
Robert G.
2/11/2026
Using that measurement, I can calculate how much I can move the pin hole forward to reduce the pin to ball horizontal distance. A local fabricator can drill a new hole for me. My Audi Q7 recommends no more than 6" for the pin to ball measurement. I need a 7" rise so coupling this ball mount with a ball that has a 2" rise gets me close to level.