Where Does Red Wire of 4-Way # 62990 Wire To on Trailer

Question

Question:

Have 5 wires what is the red one for.?

asked by: Dave

0

Expert Reply:

While we do not carry the 4-way kit part number 62990 I can tell you how it wires up. Basically the harness is a wishbone 4-way which has two wires for the running light circuit. One for each side of the trailer. The red wire goes to one side of the trailer's running lights and the brown goes to the other. Doesn't matter which side you pick.

We have a similar wishboned 4-way wiring harness as part # A35W42B.

expert reply by: Jameson C

0

Answer 1

A 5.30x12 tire such as part #AM10064 is around 21.7" diameter x 5.3" wide whereas a 5.70x8 tire such as part #AM10013 is around 18.1" diameter x 5.7" wide. Therefore, the new tire will be 3.6" taller x .5" narrower than…

view full answer...

Answer 2

To select a set of replacement idler hubs for your Fleetwood Destiny trailer you want to match up a few characteristics from your originals. These include the axle weight capacity, wheel bolt pattern and the bearing set used in the hubs. A…

view full answer...

Answer 3

I would be happy to help you find the correct tires for your new to you 1994 Coleman Destiny Cedar XL. Since the distance between the adjacent holes in your wheels measured 2-3/4" apart, you are correct that you have the 5 on 4-3/4" bolt…

view full answer...

Answer 4

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 5

The Dexter Trailer Springs Over-Under Conversion Kit part #K71-384-00 CAN be used with slipper springs. However, the process of installing this kit on a trailer with a set of slipper springs is more in depth than installing this kit on a trailer with…

view full answer...

Answer 6

Since one end of a slipper spring is suspended instead of bolted to a hanger or shackle strap the Dexter Trailer Springs Over-Under Conversion Kit part #K71-385-00 and other likes them are considered unsafe for slipper springs. The only other option…

view full answer...

Answer 7

Your current wheel and tire size has an overall diameter of 18.1 inches. The size you are looking at, 5.30-12, has a diameter of 21.9 inches. If you have the room for the additional tire size and you get the correct wheel bolt pattern then what you…

view full answer...

Answer 8

As long as you have the needed wheel well and trailer frame clearance, there is no reason that you couldn't go to a larger tire size from your existing 5.30-12 tires. The next size up from what you have is going to be with an ST175/80-13 size…

view full answer...

Answer 9

I can absolutely understand not wanting to take your hub apart to find the right replacement hub, but unfortunately that is the only option as the numbers you referenced are not any type of indicator of a replacement. So, to determine the correct hub…

view full answer...

Answer 10

The dry weight of your 1993 Coleman Cedar Pop-Up camper is right at 1,000 lbs. You then have to add anything you've loaded into it to that number. Divide that in half and each tire should have a weight rating that is above that. The Kenda 5.70-8…

view full answer...

Answer 11

It sounds like your 2-3/4" hole measurement comes from the pilot hole diameter and you are comparing that to the 4-1/2" measurement from a 5 on 4-1/2 bolt pattern. When measuring the bolt pattern on a wheel like yours with an odd number of…

view full answer...

Answer 12

I was able to locate the correct bearings, races and seal that correspond to the part numbers you provided in your question. For bearings you will need the part #L44649 and for races you will want #L44610. Then for the grease seal you will use part…

view full answer...

Where Does Red Wire of 4-Way # 62990 Wire To on Trailer

Product Page this Question was Asked From

Continue Researching