Can Trailer LED Taillight be Used as Vehicle Taillight
Updated 05/09/2018 | Published 05/08/2018
Products Featured in This Question
Question:
I am wanting to use trailer lights on a car I’m building.How do I wire the lights up do I need to do anything special?
asked by: Dale B
0
Expert Reply:
Trailer taillights install and wire up just like vehicle taillights. For example if you used the LED taillight part # STL111RB you'd need to use the install harness # A47PB which uses the white wire for ground, the black wire for tail light, and the red wire for stop/turn signal.
For a grommet you'd then need the part # A70GB.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
GloLight Halo LED Trailer Light - Brake, Tail, Turn - Submersible - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-7/16L x 2-5/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Replacement Tail Lights and License Plate Light for a Triton PWC LTWC1 Trailer
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Q&A: Replacement Brake Pads for Dexter 3,500 lb Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Recommended Aluminum Oil Cap Cover to Replace a Dexter 21-88
- Q&A: What Info is Needed to Pick Out Cushioned Equalizers for Jayco Bunkhouse
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: What's Needed To Upgrade From 5,200 Lb to 7,000 Lb Trailer Axles
- Article: Converting Your RV Water Heater to Tankless
- Article: Most Popular Wheel Bearings
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision