Recommended Wiring Harness for 2018 Buick Enclave and Tekonsha Brake Controller


i have a Tekonsha P3 6-160-153 N26802controller from my old 2011 Buick Enclave and want to install it on my new 2018 buick enclave. the harness from the controller does not match the male pin adapter on the car. do you sell the new harness. Respectfully


Expert Reply:

For your Tekonsha Brake Controller, the custom wiring harness # 3026-P is not a confirmed fit for your 2018 model as it was for your 2011 model. At this time we don't have a confirmed fit from any of our manufacturers. It appears that Buick has changed their connector and the only fit at this time is hardwiring the brake controller. For that, you can use the Replacement Brake Control Plug-In Harness for Tekonsha and Draw-Tite Brake Controller 12" Long # 20127. I've attached a wiring article to assist, but you will also want a circuit tester like # PTW2993 for that installation.

expert reply by:
Jason S

Products Referenced in This Question

Product Page this Question was Asked From

Follow up Questions

Similar Expert Q&A Pages

See More Q&A Expert Answers >>