Flush Mount Stop Turn and Tail Lights for a 1982 13 Foot Scamp Travel Trailer

Published 08/16/2011

Products Featured in This Question

Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diodes - Round - Red Lens

(2241)

$18.73

3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead

(396)

$4.97

Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead

(690)

$8.68

Dual LED Trailer Tail Light - Stop, Turn, Tail, Backup - Red and Clear Lens

(87)

$67.44

Optronics LED Transit Tail Light - Stop, Tail, Turn - Submersible - 31 Diodes - Red Lens

(93)

$40.78

Question:

the trailer does not have any holes cut for lights just screw holes that can be filled if they dont match so exact size doesnt matter. I need flush moun, definitely want LEDs I have three wires will these work and do I need anything else? current lights are: relfect-o-lite 110-150 AE IASTL-68

asked by: Jane L

Expert Reply:

I did a bit of research on your trailer and the reflect-o-lite light that you mentioned. It looks as if they are surface mount lights that are 6-7/8 inch diameter. For a replacement you could use the 7 inch round Transit LED Stop/Side Marker/Tail Light, # STL90RB, to have a somewhat original appearance, with an upgraded LED light. You could also use a surface mount like the I recommend the Dual LED Trailer Tail Light - Stop, Turn, Tail, Backup - Red and Clear Lens # CE86FR by Command electronics, which would be large enough to cover the original mounting location.

If you wanted to install a flush mount light the Sealed, 4" Round LED Trailer Stop, Turn and Tail Light, # STL42RB, would work well but would require cutting a hole in the trailer body to flush mount the light. This light requires a 3 wire pigtail, # A45PB or # A47PB, for wiring the light.

expert reply by: Robert G