Installing On/Off Switch for Backup Camera Observation System
Updated 05/02/2018 | Published 05/01/2018
Products Featured in This Question
Question:
Where does the backup power cable connect. The camera is always on and I want to install a switch as recommended in the instruction manual for the Furrion backup camera FOS48TA-Bl. When I pull the fuse that powers the garage and one outside light the camera is off also so at least I know it is attached somewhere in that circuit. I checked the closest inside garage light and did not find the connection to the backup camera. I do want to have it powered on while traveling so I can monitor the traffic behind me.
asked by: Bob G
Expert Reply:
Since you want to use the Furrion Digital Wireless Observation System when traveling, the best option is normally to wire the camera into your running lights. If you wish add a switch like # PK34513 or # D16740 in line you can simply run that power wire to the battery instead. Unfortunately I don't know where the junction is on your specific trailer, so you will need to trace that wire at least to where you would like to add the switch.
If you don't already have the Furrion System, I recommend # FOS43TASF which is their updated option.
Product Page this Question was Asked From
Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen
- RV Camera System
- Backup Camera
- Observation Camera
- Built-In Microphone
- Touch Screen
- Anti-Glare
- Mirrored Image
- Night Vision
- Motion Detecting
- Waterproof
- Pre-Wired RVs
- Wireless
- Standard View
- Dashboard Mounting Bracket
- Suction Cup Mount
- Rear
- 4.3 Inch Display
- 1 Camera
- Furrion
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Furrion RV Camera FRCBRKT-BL Review
- Video: Furrion Vision S Wireless RV Observation Camera System Install - 2020 Grand Design Reflection Fifth
- Video: In-Depth Review of the Furrion Vision S Wireless RV Backup Camera System w/ 3 Cameras
- Shop: Rear View Safety Backup Camera System with Trailer Tow Quick Connect Kit - 2 Cameras
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Should 12 Volt Hot Lead on 7-Way Trailer Connector Be Hot All the Time, WIll it Drain the Battery
- Q&A: Rearview Safety Backup Camera Kit Recommendation with Quick Disconnects for Use with Trailer
- Q&A: Will 12V Wire at Vehicle End Trailer Connector Be Hot Even When Truck and All Lights Are Off
- Q&A: How to Install a Furrion Camera System on a Forest River RV Rockwood Geo Pro
- Q&A: Do The Camera Wires On The RVS Backup Camera System Need To Be Installed Away From Other Electrical?
- Q&A: Backup Camera Does Not Power Up When In Reverse But Powers When In Drive
- Q&A: Leaving Rear View Safety Cameras On When Driving Forward