Recommended A-Frame Jack Mounting Support Plate For Standard 3 Inch On Center Mount
Updated 04/19/2018 | Published 04/18/2018
Products Featured in This Question
Question:
What is the bolt-on spacing. I need 3inch front to back 2 and 3 1/2 across the back.
asked by: Dennis
0
Expert Reply:
The Lippert Components # LC285318 uses a standard 3 inch on center bolt pattern. You will most likely need to drill some new holes in your coupler to allow for the standard mounting when replacing your trailer jack. I recommend the Bottom Support Plate for 2-1/4" OD A-Frame Jacks - 5,000 lbs # JSP-100 if you are concerned about the stability in that location with the additional holes.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is Parts Diagram Available for Lippert Electric Trailer Jack
- Q&A: Correct Replacement for Lippert Power Gear Jack 181794
- Q&A: Does the etrailer Sidewind Trailer Jack for a A-Frame Trailer Come w/out a SnapPad?
- Q&A: Looking For Replacement L-Pins For Weight Distribution Hitch
- Q&A: Replacing FIC ETJ3500 Jack With etrailer Electric Trailer Jack on 2021 Jayco Jay Flight SLX 242BHS
- Article: The Best Electric Trailer Jacks of 2025
- Q&A: Looking For Electric Jack That Can Be Rotated 90 Degrees
- Q&A: Replacement For Lippert Power Tongue jack On A Jayco Jay Flight 32BHDS
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Wiring Diagrams
- Article: How to Install an Electric Trailer Jack
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: RV Converter vs Inverter Explained
- Article: Electric Jacks vs. Manual Jacks