Difference Between Mighty Cord Dog Bone RV Power Cord Adapter # A10-1530HVP and # A10-1530

Question

Question:

What is the difference between Mighty Cord a10-1530HVP and a10-1530???

asked by: Eli

1

Helpful Expert Reply:

While the Mighty Cord Adapters part # A10-1530HVP and # A10-1530 are very similar there is one key difference. The wire gauge of the # A10-1530 is 10 gauge and the # A10-1530HVP is 12 gauge.

expert reply by: Jameson C

1

Answer 1

When installing The Stealth Hitch #SH89VR onto your 2023 BMW X5 there is no type of fascia or bumper trimming needed in order to install it. The bumper and fascia will remain intact, but there is a small piece that is underneath your vehicle that you…

view full answer...

Answer 2

Hey Whit, thanks for reaching out. We do indeed have a hidden hitch for the 2022 BMW X3 M, although it is not the "hidden hitch" brand from Draw-Tite. What we have is the Stealth Hitch Class 4 Hitch #SH59VR. The hitch itself installs behind…

view full answer...

Answer 3

We do have a hitch for your 2021 BMW X5 M. However, the correct hitch depends on what you mean by M. If you have an actual M performance model, which would be the M or the M Competition, then the correct hitch is the #SH64MR. If you plan on using it…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Difference Between Mighty Cord Dog Bone RV Power Cord Adapter # A10-1530HVP and # A10-1530

Products Featured in This Question

Continue Researching