What Wiring and Accessories are Needed For Side Marker Trailer Light # A91AB
Updated 08/01/2011 | Published 07/31/2011
Products Featured in This Question
Question:
how do you mount the A91AB if it is submergable. Does it have one wire out or do you need a pigtail.
asked by: Bruce D
0
Expert Reply:
The Sealed, Mini Rectangular Trailer Clearance and Side Marker Light, # A91AB, requires a pigtail and a mounting bracket. The pigtail is # A91LW. I have included a link to a video showing a typical installation for you.
For a bracket, there are a couple of options. For black, use # A91BB. For a chrome finish, use # A91CB.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Optronics Trailer Clearance and Side Marker Light - Submersible - Rectangle - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- Incandescent Light
- 2-1/2L x 1-3/16W Inch
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can TecNiq Contoured Taillight Replace Wesbar # 281595
- Article: Trailer Wiring Diagrams
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Best Replacement Actuator for a Titan Aero-6000
- Q&A: What Size Cut Out to Install etrailer D-ring part # RRING-Q6000
- Q&A: Recommended Replacement for Duraflex 3,500 Pound Axle
- Q&A: Replacement Brake Actuating Coupler for Atwood 85778
- Article: Trailer Lighting Requirements
- Q&A: What is the Offset of a Trailer Wheel
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule