Single Step Recommendation for Outside of Class C Motorhome

Question

Question:

Is there a possibility of a porch step with platform with only one step. A Class C motorhome sits lower to ground with a door clearance of about 18 - 19 inches in height.

asked by: Anita W

0

Expert Reply:

We have single step platform steps like the part # PA-100 for something that you'd set on the ground in front of the motorhome door.

Or if you were looking for something that attaches to the motorhome we have the Flexco manual pull out step part # SMFP-1100.

expert reply by: Jameson C

0

Answer 1

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

Hi Duane; the AeroTread Running Boards #AA2061031 fit the 2025 Durango if you do not have OE side skirts. I believe the R/T comes with the side skirts so they would not fit. For running boards that will fit with the side skirts I recommend the Aries…

view full answer...

Answer 7

Great question. Yes you can use the Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU #FR93FR to replace your Suburban water heater. It does not have an active freeze protection and will need to be winterized. It will perform best…

view full answer...

Answer 8

Hello Bruce, thanks for reaching out. We may have a light that will work for you, but I was not able to find any references for the part number D LITE SAE A216S2T2L 18. I did look over a few pictures of the lights on the 2021 Forest River Surveyor…

view full answer...

Answer 9

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Answer 10

You can use the Provider ST215/75R14 Radial Trailer Tire - Load Range D #TTWTRTM2157514D, which actually have a slightly higher speed rating than your L rated tire; these tires have an M speed rating, but will work just fine for you. These are Load…

view full answer...

Answer 11

Hey April. You can definitely use a lighter or a match to light the GE Profile Propane RV Range - Drop In item #GE57VR if you do not have 12v power. This process is not only covered in the installation instructions that I have linked below but…

view full answer...

Answer 12

Hey Tom. The B&B 222 comes back to the Replacement B&B RV Twist-On Gravity Water Fill Cap With Strap item #BM56MR in black or item #BM29MR in polar white. The caps mount on the B&B RV Gravity Water Inlet Hatch item #BM76MR in black or…

view full answer...

Single Step Recommendation for Outside of Class C Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching