Back Up Alarm Recommendation for Vehicle with 921 Style Reverse Light
Updated 02/19/2018 | Published 02/18/2018
Question:
Is there a back-up buzzer that is plug and playfoot to replace a 921 bulb?
asked by: Chris
Expert Reply:
I may have a solution for you, however we do not currently have a combination reverse 921 light bulb and back up alarm available. We are not aware of when one might become available.
We do have the stand alone Pollak Light-Duty to Medium-Duty Back-Up Alarm with Wire Leads # PK41820. This will install on the underside of your truck and tap into the reverse light wire. I have attached a demonstration video on this product as well as a link that will take you to our available selection of alarms and sensors.
Product Page this Question was Asked From
Light-Duty to Medium-Duty Back-Up Alarm with Wire Leads - 12-24 Volts - Less than 0.3 Amp - 97 dB
- Back Up Alarm
- Low Volume
- Steam-Cleanable
- Voltage Spike-Protected
- 97 Decibels
- Surface Mount
- 12V
- 24V
- Pollak
more information >
Continue Researching
- Q&A: Does the Bigfoot Hydraulic Jack Come with the Switches or Remote?
- Q&A: How Do Wires Connect to TowSmart ProClass 7-Blade Trailer Connector w/ Wire Tester
- Q&A: How do I Trickle Charge a Battery on my Trailer
- Q&A: Can Redarc In-Vehicle BCDC Trailer Battery Charger Charge Two 100 Amp-Hour Batteries
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Solar Panel for a Redarc In-Vehicle BCDC Trailer Battery Charger
- Q&A: Trailer Brakes Lock Up When Connected to Truck
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Stability Control for Heavy Duty Vehicles
- Article: Testing Brake Controls
- Article: Testing Breakaway Systems