How to Remove the Trailer Hitch Receiver Lock Part # e98880
Updated 01/15/2018 | Published 01/13/2018
Question:
I unlocked it. Now how to remove it all the way off of the trailer!?
asked by: Tylene
0
Expert Reply:
The Trailer Hitch Receiver Lock part # e98880 is threaded on the end where the lock is located. Once the key has been inserted into the locking cylinder you will then need to rotate it counterclockwise until the threaded section is no longer attached. You may need to hold the opposite end of the lock to help keep it from spinning with the locking core.
You can see this process done in the video I have attached for you.
expert reply by:
Conner L
0
Product Page this Question was Asked From
etrailer Trailer Hitch Receiver Lock for 2" Hitches - Flush - 2-5/8" Span - Chrome
- Trailer Hitch Lock
- Standard Pin Lock
- Keyed Alike
- Chrome
- Fits 2 Inch Hitch
- Flush Pin
- 2-5/8 Inch Span
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Recommendation for GCH10A3E Atwood/Dometic Water Heater
- Q&A: Atwood RV Water Heater Replacement for GCH10A-3E
- Q&A: Will Air Lift 1000 for 2025 GMC Acadia Fit 2025 Chevy Traverse
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will the Andersen Weight Distribution Hitch w Sway Control AN28VR Raise the Hitch Ball 6"?
- Q&A: Is There A Water Filter Kit For RV That Spends Some Time At Campground And Some Off-Grid?
- Q&A: Recommended Baseplate Kit for a 2023 Ford Bronco w/ the Ford Performance or Standard Plastic Bumper
- Q&A: Does etrailer Base Plate Kit Fit 2025 Ford Bronco Raptor
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Anti-Rattle Devices
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft