Aluminum Tread Plate Trailer Fender # HP96VR Recommendation
Updated 06/22/2011 | Published 06/19/2011
Products Featured in This Question
Question:
Is this product galvinized? I am looking for a bolt on application on a Magic Tilt saltwater trailer. It is for an 18 center console with 14 tires. The current fenders are 8 3/4 wide X 29 long X 12 tall. Do you have something like this?
asked by: Simon
Expert Reply:
If you are looking for a fender for your trailer that will resist corrosion I would recommend the Aluminum Tread Plate Trailer Fender # HP96VR as it is made of aluminum and will resist corrosion more than steel.
The 16-Gauge Steel, Single-Axle Trailer Fender # HP29VR that you referenced is not galvanized and would be a lot more susceptible to rust and corrosion than the # HP96VR .
Product Page this Question was Asked From
Single Axle Trailer Fender for Enclosed Trailers - Cold Rolled Steel - 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 15 Inch Wheels
- 10-3/4 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Q&A: How To Bolt-On, Weld On Trailer Fenders
- Q&A: Can I Wire 2 of the Atlas IV Vaquero Self-Contained Hydraulic Trailer Jacks Together?
- Q&A: Replacement Master Cylinder For Titan Model 60 W/ 23361 Master Cylinder
- Q&A: Is it Okay to Tow a Trailer without Fenders
- Q&A: What is the Difference Between Curt and Towsmart Hitches for a 2025 Kia Sportage
- Q&A: What is the Difference in the MORryde Hand Rail?
- Q&A: Availability of Replacement Grease Seal 450133
- Article: Most Popular Wheel Bearings
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hitch Mounted Cargo Carrier Information
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Best Bike Racks for Electric Bikes